View Single Post
Old 01-17-2018, 04:07 AM
bokku01 bokku01 is offline
Junior Member
Join Date: Oct 2016
Posts: 24

Thank you for your reply

Here I attached the STL file from the seminar.

According to your words, my own STL file must be matched the vertices and faces and also anatomical position. If I get my own STL file from MRI data, the vertices and faces of the source STL file and my own STL file cannot be matched even anatomical position. (Actually I matched vertices and faces of my own STL file with source STL file by Hypermesh software but I couldn't match vertices anatomically)

I am little confused.

My question is, How can I apply my own STL file with the code from the seminar? I just thought that it works well with any of STL file with any topology.

Here I attached the sourse and target STL file also from the seminar.

Thank you for your advice.

Best Regards
Attached Files
File Type: zip (1.61 MB, 0 views)
Reply With Quote