Forums Anyscript.org  

Go Back   Forums Anyscript.org > General Forum > AnyBody Modeling System

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 12-03-2017, 08:13 PM
sdsk sdsk is offline
Junior Member
 
Join Date: Dec 2017
Posts: 1
Question AnyKinPointSurface normed measure

Hi

In the documentation for AnyKinPointSurface it says that the normed measure is calculated as



I have two questions relating to this calculation:

1) Is this last log supposed to be read as "log(Exponent) times d_i" or as "log base Exponent of d_i"?

2) If I measure distances individually and then try to calculate the normed measure "by hand", it is different from the value I get from AnyBody. This is no matter which of the two calculations mentioned in 1) I use. For instance: in one frame I have four distances (0.0329, 0.0244, 0.0254, 0.0297) with Base 1.0 and Exponent 20. Using "log(Exponent) times d_i" I get 0.451 and using the other calculation I get 0.862. From AnyBody I get -0.4347 (note the minus). Any ideas why?
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 04:23 PM.