Gait modeling process

Main Forum
,
1

Hello team,

This might be a basic question however, I would like to go further into how AnyBody performs the Inverse Dynamic Analysis in a gait model. I have some c3d data obtained with Vicon for a Force Plate type 2. I am evaluating the joint reaction forces in the L4L5 vertebral segment. I have 2 force plates and the respective ground reaction forces. I am wondering how AnyBody commutes these reaction forces. I am trying to understand if the output obtained corresponds to some sort of "average" between the two forces plates for the whole gait cycle or if there is any other process.

If you have any papers I can refer to would be greatly appreciated. Thank you.

Maria Prado.

1 Like
2

Hi @MariadelMarPradoG92

Here is a few references you can look into:

Best regards,
Bjørn

1 Like
3

Thank you Bjorn,

I will check the papers

4

This topic was automatically closed 125 days after the last reply. New replies are no longer allowed.