Help request for testing the incline press machine model

Main Forum
1

Hi,

I’d like to ask a favor of you about my model.

This model includes the incline press machine combined with the AnyBody human model.

I used AnyBody 4.1.0.1006(Build 14579.43980) version with AMMRV1.2.

I’d like to ask of you for two reasons.

  1. I could perform the kinematic analysis and the inverse dynamics analysis. I used ‘KinSolOverDeterminate’ solver type for over constrained system.
    But my model generates a lot of kinematic errors in AnyBody 4.2 version. I’d like to know the reason.

  2. When I try to perform the inverse dynamics analysis, a lot of penetration warnings for via-points occurred. Would you please let me know how I should remove these warnings?

Best regards and thanks always for your supports,

2

Hi,
I ran your model and didn’t get kinematic error with 4.2. Are you running the latest release? Could you please post what is happening, as I cannot reproduce it its hard to judge. The peneteration you see is in some muscles in the radius, It seem the wrist is in quite some flexion, in this position a viapoint pentetrates the wrapping surface. The fix is to visuallize the viapoints and the wrapping surface and slightly change the definiton of one of them.
Best regards,
Sebastian

3

Hi,

Yes, when I first loaded my model, sometimes the kinematic analysis goes well without errors. But it is the only one time.

When I reload the model by using F7 button and retry to run the initial conditions, I could see the error.

I attached the error log file.

Of course I’m using the latest AnyBody 4.2 version from your official site.

Best regards,
Moonki

4

Hi Mooki,
sorry for the trouble you’re experiencing. We found the issue, there will be a updated version of the AMS available in a few days.
Best regards,
Sebastian

5

Hi, Sebastian.

Thanks for your reply. I hope to get the updated AMS.

Best regards,

6

Hi Moonki,
please have a look at the anybodytech.com page. In the download section, under subscription services is a new version available. That should fix the issue.
Best regards,
Sebastian

7

Hi Sebastian,

I downloaded the new version and tested it with my model. It works well as in AnyBody 4.1 version.

Thank you very much for your rapid update.

Best regards,
Moonki